These are some shots of my timber PC case. Took me a few days to make..
Was sick and tired of staring at the old plastic one...
Did the basic inside clean up / led fit out.
Case is made from 3/4 in pine solid board.. With Tasmanian oak trim...
It has a lovely aroma when warm. Several fans and port's have also been added to accomadate for the timber. I have active monitor's and warnings setup "incase" anything goes wrong....
In regards to the obvious comment's about combustibility of a timber case..
I would tend to agree with many other's, that the plastic's contained in standard case's, would be equally combustable. Although it would also emit toxic fume's..
I was going to do alot more "fancy" work to it, but preferred to go for the less is more look...
On the front are stainless steel fitting's. The only button is the on/off in the middle there... DVD drive is ejected via OS.. The on/off and headphones hanger are from a single magnetic stainless door catch...
My flat screen monitor may get the same treatment.
Sorry about the low qual pics...
No comments:
Post a Comment